Uvps Lamp Voltage Interface B003-001 User Manual download pdf

Lamp Voltage Interface™

Installation and Operation Instructions

Model No. B003-001

SAFETY

1. To ensure safe installation and use of your Lamp

Volt Interface™ (LVI™), please direct all users

to read this technical sheet.

2. Turn off the power supply at its source before

installing this unit, or before performing any

maintenance work.

3. ALLOW TIME FOR CAPACITORS TO

DISCHARGE BEFORE WORKING ON

ANY POWER SUPPLY.

4. DO NOT TOUCH EXPOSED POSITIVE OR

NEGATIVE INTERFACE LEADS WHEN

INSTALLING THIS DEVICE.

5. Keep flammable materials a minimum of three

feet from any operating equipment.

6. Do not alter the wiring of this unit prior to,

during or following installation.

7. The LVI™ permits volt reading by a high

impedance meter by reducing the actual reading

to 1/100

of actual power. Therefore, an actual

voltage of 2000V would be displayed as “20.00.”

INSTALLATION

The Lamp Volt Interface™ must be installed parallel

with the curing system’s UV lamp wiring. Therefore,

connector leads are to be installed directly over

respective lamp leads connected to ballast and

capacitor terminals.

1. With electrical power shut off at the source, open

the power supply cabinet to expose your curing

equipment’s electrical components. Allow

enough time for capacitors to discharge all

electrical energy before beginning any work.

2. Loosen and remove the nut that secures the lamp

lead to the ballast terminal. Do not remove the

lead from the terminal.

3. Slip the round, closed-end LVI™ connector lead

over the ballast terminal and secure.

4. Locate the first capacitor that is wired directly to

the first mercury relay. Plug the stab-on

connector onto an available tab on the capacitor.

5. Mount the LVI™ junction box to the inner side-

wall of the power supply cabinet. This unit can

be mounted by drilling two holes in the side of

the cabinet, and securing the junction box with

two #6, #8 or #10 screws. Proper mounting will

prevent excessive vibration and ensure

consistent, long-term performance.

6. Connect the interface leads into appropriate +/-

screw receptacles on a high impedance, panel-

mount volt meter (must be a true RMS volt

meter; available directly from UVPS).

7. Close the power supply cabinet when assembly

is complete. Turn power on at its source.

OPERATION

1. Turn your curing system or machinery on.

2. With the LVI™ integrated directly between your

curing system’s incoming power source and the

capacitor, the panel-mount voltmeter will

indicate (via its LCD or LED display) volt levels

at .01 of actual power. Therefore, for units

operating at 2450v, the voltmeter will display a

reading of “24.50v”.

1 2

Lamp Voltage Interface™ 1

Summary of Contents

Page 1 - Lamp Voltage Interface™

1Lamp Voltage Interface™Installation and Operation InstructionsModel No. B003-001SAFETY1. To ensure safe installation and use of your LampVolt Interfa

Page 2

2Lamp Voltage Interface™Installation and Operation InstructionsModel No. B003-0013. As volt level directly corresponds to lampperformance, the meter’s

Comments to this Manuals

No comments

Uvps Lamp Voltage Interface B003-001 User Manual

Browse online or download User Manual for Tools Uvps Lamp Voltage Interface B003-001. UVPS Lamp Voltage Interface B003-001 User Manual

Summary of Contents

Comments to this Manuals